View Full Version : General
- 5.0 twin turbo manifolds
- Pics of electric exhaust cutouts...
- Differential vent
- Off goes the old.............exhaust.......pic
- eBay CAI problem..yes I searched.
- 1996 Mustang convrtible value
- Cammed guys.. does your car run hotter with the cam?
- 87 , 88 or 92 Octane ? ?
- Never ending story....
- Never ending story....
- 87 , 88 or 92 Octane ? ?
- glass tint removal
- Copuld the CPS cause me to run rich?
- hesitation/backfire
- engine gets installed wed....plus parts i need. pls read
- Clutch adjustment trick
- What does nonIRS mean?
- Should I go with 160 or 180????
- Intake Spacer
- Oil spray from forward universal joints?
- clutch and flywheel
- What is needed for IMRC deletion?
- pretty neat step by step mods
- Parts compatiblity question.
- need to get new fuel lines....
- 99 up throttle body and throttle body spacer
- Tire sizes?
- 1/4 mile decrease
- Stock intake=Check engine?
- Whats the best way to prevent center caps from falling off?
- SPARK PLUG WIRES ( BIG DIFFERENCE ? )
- Can anyone awnser this ( Diablo Question )
- 80mm MAF on a 94-98 MAC CAI
- Good news on the 2006 Mustang
- using 95 gt t5 & bell. bolts,pilot bearing,block plate Q's
- newbie question (I feel like an idiot)
- Sparkplug gap
- wheel fun
- 3.73 Gears Install ( After Diablo Chip ) ??
- Which would you do?
- O2 sensor and saprk plug question
- Rim and tire change
- exhaust rattling/touching DS safety loop
- What would cause a dead spot at certain RPM (4000)
- Exhaust ???
- A CAM QUESTION
- what could be wrong?
- New Stang
- 1st gear and then ( Oh No )
- MAC LT's and Catted h-pipe question..
- Squeking sound when Turning
- Long Tubes on..........sweet........pics
- AODE TO MANUAL TRANSMISSION
- 4.10 or 3.73
- How to use a truck SPI lower intake on a Mustang...
- 233hp and 250tq AGAIN!!!!
- Sound Clips of my turbo spool and magnaflow race muffler
- I'd like to thank Justang2k...........
- How much for a high performance clutch and pressure plate
- help me !!!!
- Pulling 3.8's, and hints and exprerience?
- Where are these wires located?
- Several questions i need answered...
- got a new message forum for my site
- throttle body spring?
- quick axle question...
- 3.8 ARP main bolts, best/only place to get them is Morana?
- lightweight drycell batteries???
- deltaflow 40's 2 or 3 chambers?
- Cold air intake for 2003 V6
- Has anybody ever taken the dust shield in back on the rotor?
- Whats this? (EGR related)
- Cats are no good, Getting new exhaust *advice please*
- Leaky rear pinion oil seal @ 40k ?
- Turbo Hose & T-Bolt Clamps
- ENGINE IS IN, but problems with TC :(
- Head/Cam Install Planned for 03/20
- Going Way To Fast ...
- to cat or not to cat...
- Got detonation problem! HELP!
- turbo coupe???
- SUPERCHARGER
- turbo kit
- mac cat back dual exhaust
- video of what a race pulley does to your charging system
- my new mods within the next 2 weeks or so...
- Performance Wires Question
- Power steering problem !
- Kuhmo Ectsa 711 or Falken VISA?
- Udate on Project 500
- Stain Steel Valves
- Whats the strongest material that doesnt conduct electricity
- Lower intake manifold problem
- glasspacks???
- Anyone with a 3k stall..??
- Any chrome alternators available for our cars?
- Going from 40 Delta Flow's to 40 Flowmaster Orginals
- New Dyno
- just to clarify an exhaust question...
- heads/cam and nitrous - questions and predictions
- Thorttle Body Spacer
- Fuel filter
- PLS help really pissed need to rant off SMOG ISSUES
- Dallas Mustang Speed Cal
- Borg Warner T5
- Watter Wetter
- how much for a cam install
- speedo gear question
- 3.73 Gear Install
- power seats from 2000 HELPME PLEASE
- Does this sound right?
- Problem with the car, please help
- 3.8->4.3 air/fuel ratio question
- Yellow Tranny Fluid???
- Newest mod
- What sounds good on a 99 v6(Exuast).
- Motor swap done, but now have issues: (EDIT:Still)
- Help! I am replacing fog lamps on my 01
- AUTOMETER OIL PRESSURE AND BOOST GUAGE INSTALL
- what am I missing?
- How do you route your spark plug wires?
- Turbo question
- 255/40s on my 97 Cobra rims?
- an alright day for me
- Filling Tranny
- any precautions to installing new valve seals?
- any one w/ sound clips of LT's and Supercharger??
- I want 300rwhp N/A [I]BEFORE NITROUS[/I]
- Fuel Problems....need advice!
- Quick- I have a question about O2 sensors
- anybody have a T5 they wanna get rid of?
- I got track times
- Drivetrain How-To
- About halfway done with exhaust......pic....
- What shifter do you recommend?
- IF THE CATS COME OFF .... ?
- Air/fuel questions.
- is this setup worth 320-325rwhp???
- RR geometry versus stock rockers... techies get in here!
- Best place to get urethane bushings?
- Cats?
- Do v8 and v6 use same 02's
- Results of my vacuum test...
- Update on the new springs I mentioned here before:
- Header question
- Valve sizes
- guage question
- anyone have a GT aftermarket exhaust on their car?
- I need some help
- Exhaust pipe
- water temp gauge acting weird
- Light Cluth pedal feel+vibration
- Manual fan switch
- Cheap code reader
- For those who wants to know where to get injector adaptor
- my stage 3 intake
- my 8.8 gears = destroyed
- Since Tally has posted his blown up Rear End pics...
- bbk or MAC Intake???
- tools for removing 94-98 front brake calipers
- Race Manifold
- firmer clutch, stock?
- So i got my 3k Pi Torque Converter But...Look at pics
- Can Alternator brushes be replaced on '95?
- Larger Tips = More Loud ?
- recaro seats?
- intake manifold
- Oil Changes
- Help, I'm drowning
- pictures of my car with blackouts and a photoshop request :)
- car not level side to side
- O/R H = Bad mileage??
- idle bounces with a/c on?
- A/C delete?
- Took some valvetrain pictures... great detail DUW
- Tranny
- Stock 5.0 TB ?
- Speed-o Gauge calibration?
- Wash your alternator
- fog light question
- Torque Convertor
- Denso's pre gapped? What should i set the gap to
- Lug pattern measurement?
- Would this intake fit in our stangs?
- got the new parts on :)
- cold air intake???
- HELP! strange stalling problem...
- reliability
- Convertible top replacement or repair
- A little fun with rwhp estimates...
- I ran my '94 5.0 mustang
- ok finally new updates on my car
- Idler pulley help...
- Complete Clutch Workings
- My SCT Microtuner
- PROJECT 500 LIVES. IT STARTED....
- What part is this?
- need to cap off the schrader (sp?) valve cap on fuel rail
- Someone to check vac on their car and tell me what happens
- my turn for benchracing dyno2k estimates
- fan switch
- auto reliability
- blown 3.8... please help
- Tranny Gone :P What should i get?
- track times needed for cage
- Changing my Clutch Cable
- Reoccuring TO Bearing issues
- Stock rad size
- NEED HELP
- Could someone suggest a place to purchase 93 cobra R wheels?
- roush springs?
- Dust cover? or whatever between block and flywheel
- Dent in exhaust?
- 2000 and 2002 gaskets
- SN95 hub specs?
- Rear Sway Bar
- 02 sensors cause rough idle
- My air/fuel readouts at 7 psi turbo boost. Thanks Justin!
- Got my turbo
- cutting steeda springs
- ??? fuel pump ???
- Transmission or spark plugs
- VIPER VENOM 650 VS. LS1 N20 MOVIE
- SRT-4 23 PSI VS. 03 COBRA
- vIPER VS 700 RWHP SUPRA
- Those with aftermarket hoods...
- Some Mods.. expected Results ???
- going to be polishing upper, are there any tips?
- Limited Slip Differential
- Cheapest Place to Find Warlock Mufflers?
- X PIPE QUESTION
- Lowering a Stock 2000 V6 ( Yea Um... )
- depressurizing returnless cars
- Mods?
- codes p0443 & p0453 evap on 98 w/ supercoupe engine
- timing cover kit....
- lowering springs question
- RPMOutlet.com Option A?
- head/cam swap tonight! updated pics every hour
- tranny suggestions...
- '02 v6 4r70w work in a '98?
- will '00 v6 catback work on a 95 3.8??
- 94-95 Coil Pack Mounting
- '04 Mustang 3.9L ... will ASP 3.8L Underdrive Pulley fit ??
- muffler questions, down to the nitty gritty
- 4.2L Throttle Body Linkage
- strange
- Proper order of purchasing MODS
- Headlamp question???
- Underdrive pulley installation??
vBulletin® v3.6.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.